inVENTer iV14-Zero sMove Operating Instructions Manual

35, 35 APPENDIX 2: CLEANING PROTOCOL iV14-Zero ventilation system / sMove controller • Operating instructions PUBLISHER: INVENTER GMBH ORTSSTRASSE 4A D-07751 LÖBERSCHÜTZ GERMANY 7(/(3+21(     )$;    �…

14, 14 OPERATING THE SMOVE CONTROLLERS iV14-Zero ventilation system / sMove controller • Operating instructions The external interface is a bi-functional port on the back of the operating unit. It enables the connection of a sensor with a potential-free switching contact (NOC) or the use …

20, inVENTer iV14-Zero sMove Cleaning and maintenance Any necessary cleaning or maintenance work can be carried out by the user by following these instructions. TIP: Before performing cleaning or maintenance tasks, disconnect the controller's power supply and put on gloves. Detergents NOTICE The p…

13, 13 OPERATING THE SMOVE CONTROLLERS iV14-Zero ventilation system / sMove controller • Operating instructions Pressing again lets you switch between the heat recovery and ventilation modes. The indicator lights to the left of the Mode button displays the currently set mode. The…

24, 24 CLEANING AND MAINTENANCE iV14-Zero ventilation system / sMove controller • Operating instructions Cleaning and reassembling the thermal accumulator insert Soft brush, lint-free soft cloth and warm water Requirements: The thermal accumulator insert has been removed. 2 1 2 1 1 2 3 Ź Place inV…

5, 5 USER AND SAFETY INSTRUCTIONS iV14-Zero ventilation system / sMove controller • Operating instructions Safety instructions These operating instructions are part of the ventilation unit and must be permanently available. When handing the equipment/system to a third party, the operatin…