Keep Safe Sagl PERSONAL GPS 3 Operation & User’s Manual

11, 11 5. 3 Vibration Alarm When the terminal shakes for 10 seconds , it sends a SMS alarm to the SOS phone numbers authorized 1) Via calls Any SOS numbers call the terminal (must be the SOS numbers), and then end up the call in 10s by the mobile side to arm the terminal. The termi…

13, 13 6 .2 Trouble shooting If there is any problem while operating the terminal, please refer to the following table, or contact your service provider. Common problems Causes Solution Bad reception Near the tall building or in the basement Change to a place with good signal The ter…

9, 9 4.7 Set the time S end a SMS with: GMT,E,number # o Bern example (GMT+1): GMT ,E,1# 4. 8 Answer phone calls Short press either one of the Family Number buttons to pick up the call. And short press SOS button to reject or end the call. Long press either one of the Family Number…

7, Keep Safe Sagl PERSONAL GPS 3 7 4 Parameters setting 4.1 Set APN Please send SMS command to the number of terminal so as to set up the APN parameter . The terminal will reply “OK” automatically after setting successfully. Send SMS command: APN,APN name# o e.g: APN, gprs.swisscom.ch # NOTE : The APN…

4, 4 2.2 LED Indication 1. Power/working status indicator (red) Status Indication Quick flashing (interval 0.3s) Low battery Slow flashing (interval 2s) Fully charged Slow flashing (flash 0.1s after every 3s ) Normal working Continuously in bright Charging Continuously in dark No …