Hope Industrial Systems HIS-UM17 E Series Operation & User’s Manual

9, Installation Instructions UM17E User Manual, June 2010   9 Install Touchscreen Applies to touchscreen monitors only� Instructions below apply to Windows systems� Both Serial and USB ports are present on all touchscreen monitors, but only one should be used to connect the touchs…

8, Installation Instructions 8    UM17E User Manual, June 2010 Step 2:  Bench-test Conguration Make sure everything works before installing into the production environment�  TIP! Install Cable Connections The cable ports are located on the rear of the monitor� Refer to the…

29, Specications UM17E User Manual, June 2010   29 Electrical Monitor Input 100 to 240 VAC, 0�6/0�3 A, 60/50 Hz Power Consumption ~ 36 W Power Management DPMS/energy star, < 1 W Environmental Temperature 0° to 50°C (32° to 122°F) Humidity 20% to 90% non-condensing Opera…

25, Troubleshooting UM17E User Manual, June 2010   25 Symptom Causes Solutions No image on the  screen and control's  Power Indicator  light is lit orange Video cable is not plugged in correctly� Check the video cable connection at the monitor, PC, and/or K…

20, Video Settings 20    UM17E User Manual, June 2010 Color Adjust Menu The Color Adjust menu provides several color adjustment modes, including preset color temperatures and a User Color mode which allows independent adjustment of red (R), green (G), and blue (B)� The factory settin…

19, Hope Industrial Systems HIS-UM17 E Series Video Settings UM17E User Manual, June 2010   19 Auto Image Adjust Menu The Auto Image Adjust menu automatically sizes, centers, and ne tunes the video signal to eliminate waviness and distortion� NOTE: Auto Image Adjust works with most common video cards� If this functi…