HumanCentric XT Series Online Manual

1, Fits VESA patterns 100mm x 100mm and 75mm x 75mm. If your monitor doesn’t have VESA holes, check www.humancentric.com for an appropriate adapter for your model. Models 101-3001 (single), 101-3002 (dual) TOOLS INCLUDED M6 Large Allen Wrench XT-Series Monitor Mount Patented in the US, Int…

2, 2. INSTALL LOWER ARMS Install and tighten the adjustable clamp as shown. Insert the M3 allen wrench into the wrench slot. click! DUAL MOUNT SINGLE MOUNT click! Place the clamp padding between the desk and the intended clamp location. For optional permanent placement, remove …

3, 2. INSTALL UPPER ARMS 3. INSTALL MONITOR The black screw goes toward the bottom of the monitor Slide the upper arm(s) onto the lower arm(s) until the lock clicks into place. click! click! 4. ROUTE CABLES WARNING Without the monitor weight to hold the spring in place, the monitor a…

4, HumanCentric XT Series To adjust the swing tension of the arms, tighten or loosen the set screws with the M3 allen wrench. 5. ADJUSTMENTS To adjust the tension for the monitor’s tilt and rotation, tighten or loosen the monitor bracket tension screw appropriately. To adjust the spring tension for …