KRain Pro EX 2.0 Owner's Manual And Installation Instructions

12, STATION OPERATIONS RUN STATION Once the remote has established communication with a controller within signal range and a matching Pin Code, the remote will display the first available station. NOTE: Only stations with a programmed run time on the controller will be displayed and ava…

17, KRain Pro EX 2.0 16 INSTALLATION OF OPTIONAL LONG RANGE ANTENNA Owner’s Manual and Installation Instructions STEP #5 Remove the plastic caps from the RF Module cavity. STEP #6 Place the RF Module in the cavity, press down gently to connect. Using a Phillips head screw driver, tighten the two…

5, 04 SYSTEM COMPONENTS LCD DISPLAY Owner’s Manual and Installation Instructions RF MODULE (Receiver) The RF Module was designed for installation within the Pro EX 2.0 controller cabinet therefore providing permanent placement and maximum protection. Many factors influence operating range. Listed be…

9, 08 PIN CODE DIFFERENT PIN CODE After powering up the remote if no controllers with matching pins codes are found within the signal range the stored remote pin code will be displayed. SAME PIN CODE After powering up the remote, if a controller(s) with matching pins code is found …

18, TROUBLESHOOTING PROBLEM CAUSES SOLUTIONS Remote display is blank Remote is off Press and hold any button for three seconds Batteries are dead Replace with fresh batteries Battery orientation incorrect Correct battery orientation +/- LCD displays four digit Remote pin code doesn’t match Ente…

8, POWERING UP REMOTE Turn on the Remote by touching and holding any button for two seconds. While the remote powers up, it will automatically attempt to match pin codes with any and all controllers within signal range. NOTES: 1.) The default pin code is 1111. Any and all controllers with…