KOR MODEL L-410 UVP-E Turbolet Operation & User’s Manual

4, - 3 - Main landing gear mount: Glue the part „1“ to the R.H. fuselage shell (caution: part „1“ has to be glued in the correct way). Glue the 3 plywood parts together with the „C“ shaped part in the centre using the dispersion ad…

5, KOR MODEL L-410 UVP-E Turbolet - 4 - Insert the brass tube through the two fiberglass plates. Make a cut for both of them, the top plate shoud be approx. 3 mm from the top of the brass tube, the lower plate shall be approx. 10 mm from the fuselage bottom. Before glueing them …

8, - 7 - shortened later). The use of servo extension wires may be necessary, depending on the length of the ESC wires to the receiver. The 3 wires to the motor need to be long enough to come out at the front of the nacelle (opening for the cooling air). Prepare a groove in the wi…

7, - 6 - The center section of the wing: Glue the parts „9“ and „10“ together. Glue the plywood part with the corresponding shape to the rear face of the center section of the wing. Cut two pieces of 2 mm carbon rod with the length of 50 mm, insert and glue them into the …

3, - 2 - Technical information: Wingspan: 1270 mm Overall Length: 920 mm Flying weigth: ~700g RC Functions: Rudder, elevator, ailerons, motors (throttle), optional flaps Recommended equipment: Brushless motor: Emax CF 2812 2 pc Electronic Speed Controlle…