Hytera PD982 Manual 

37, 31 Step 2 Press the Up or Down key to change the value, and then press the OK/Menu key. It is recommended that you set the frequency gains according to the following table: Scenario Low Frequency Gain (dB) Mid Frequency Gain (dB) High Frequency Gain (dB) Square 0 3 5 Indoor 3.…

35, 29 If you want to... Then... Turn all visible and audible indications off Select Covert Mode, and then select On. Allow or disallow the radio to send its alias during voice transmission Select Send Alias, and then select On or Off. 8.2 Contact Management 8.2.1 Adding C…

46, 40 or Tight (from low to high) as required. Generally, a higher squelch level requires higher signal strength. If the squelch level is set to Open, the speaker will always keep turned on. 8.18.5 Setting the CTCSS/CDCSS Feature The Continuous Tone-Coded Squelch System (CTCSS)/Continuous Digit…

17, Hytera PD982 11 4.7 Selecting a Zone and Channel (Conventioal) In conventional mode, the radio receives and transmits data and voice on the selected channel. A zone is a group of channels within the same operational area. To select a zone and then a channel contained in it, do as follows: Step 1 Select…

9, 3 2. Product Overview 2.1 Product Layout No. Part Name No. Part Name 1 Side Key 1 (SK1) 12 LED Indicator 2 Push-to-Talk (PTT) Key 13 Antenna 3 Side Key 2 (SK2) 14 On-Off/Volume Control Knob 4 Top Key (TK) 15 Accessory Connector 5 Channel/Group Selector K…

11, 5 3. Before Use 3.1 Attaching the Antenna Caution  Rotate the antenna clockwise until hand tight; if over tightened, the antenna or its connector may be damaged.  Do not hold the radio by its antenna as it may reduce the radio performance and life span of the antenna. 3.2 Ins…