KUHN GF222T Operator's Manual

35, Maintenance and storage Gyrotedder GF222T 33  Grease The rotor housings. The tedding rotor locking system. The guard lock. The pitch angle adjustment handle and its pivot pin. …

37, Maintenance and storage Gyrotedder GF222T 35  Replacing a tine From the working position: - Remove attachment screw (1). - Replace tine. Before leaving the tractor or before adjusting, maintaining or repairing the machine, disengage the PTO drive, turn off the engine, remove igniti…

14, Gyrotedder 12 GF222T Safety  Precautions during manoeuvres When moving the machine from the transport position to the working position and vice versa, make sure that nobody is within the machine pivoting area.  Remote controlled components Danger of crushing and shearing can exist when com…

34, Gyrotedder 32 GF222T Maintenance and storage 2. Lubrication The pictorials show the points to be greased (Part no. 09905400). Clean grease nipples before greasing.  Lubrication - Every 20 hours: • U-joints (1). • Transmission tube (2). - Every 100 hours: • Guide rings (3). Before carrying…

23, Putting into service Gyrotedder GF222T 21 2. Coupling and uncoupling  Preparing the tractor The machine adapts to tractors fitted with a pull bar. The tractor nominal PTO speed must be 540 min -1 .  Coupling the machine - Couple machine to tractor and secure hitch pin. Safety chain The…