mangOH Red Operation & User’s Manual

6, Rev 2 May.17 6 41110400 1 1: Introduction This user guide explains how to set up and begin using the mangOH™ Red with CF3 (Common Flexible Form Factor) modules. Once you have the mangOH Red set up, visit mangoh.io for developer documentation, code samples, and other materials. Note: Described …

32, mangOH Red User Guide Rev 2 May.17 32 41110400 Figure 3-29: mangOH Red Assembly—Top Side Switches/Connectors Note: For reference only. For latest schematic, visit mangoh.io. LowPower_RESET 8 On When combined with LowPower_RESET, indicates that board is in WP mode. Off (Default) When …

19, Hardware Setup and Features Rev 2 May.17 19 41110400 SIM, SD, and IoT Expansion Cards Inserting a micro-SIM Card To establish a mobile network connection with a CF3 module, you must install a micro-SIM in the connector on the bottom side of the mangOH Red. Use either of the following: �…

28, mangOH Red mangOH Red User Guide Rev 2 May.17 28 41110400 Physical Switches Reset Switches The mangOH Red includes two reset switches: • Board reset (SW400)—Press and hold for 5 seconds to reset the board. Note: When the board is resetting, the reset signal is held LOW until the CF3 module is fully …

4, Rev 2 May.17 4 41110400 Contents Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 mangOH Red Components and Accessories . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 …

29, Hardware Setup and Features Rev 2 May.17 29 41110400 mangOH Red Configuration Default Configuration The mangOH Red‘s default configuration is described in Table 3-4. Switch and Jumper Configuration Options The mangOH Red uses several switches and jumpers to configure the board and…