Nauticam NA-Ninja V Instruction Manual

12, 12 O PENING AND L OCKING THE H OUSING To open the housing: 1. Press the housing lock safety button. 2. Turn the housing lock 270°, counter clockwise, until the lock reaches the “Open” position as shown. …

16, 16 2. Switch the alarm on. The LED light will flash blue once and turn blue for five seconds indicating the battery is normal. Then it goes into flashing blue light standby mode. 3. Test the alarm by connecting the two wires near the bot…

21, 21 1. Before mounting the camera, connect HDMI 2.0 cables (IN and OUT) to the camera’s HDMI connectors accordingly. Then place the monitor inside the housing 2. Secure the monitor by turning the two locking levers towards the moni…

18, 18 LED indicator Status Flashing "Blue" light Standby mode. The moisture alarm is active, and the system is ready for vacuum indication whenever a vacuum is detected. Flashing "Red" light with beeping sound Moisture is detected. Flashin…

17, 17 Vacuum valve: Vacuum valve is pre-install to the housing for conducting a vacuum seal test. Please refer to the manual of the vacuum valve for details of the operation. LED status identification: On start up LED indicator Status Flash “Blue” light once Indicates a …