Line 6 HX Stomp Owner's Manual

15, 15 Setting Path B's Output There may be situations where you want parallel path B to be sent to a completely dierent set of outputs. 1. From Edit view, turn the Upper Knob to select the point where the two paths merge. The Mixer block appears only when selected: 2. Press ACTION an…

27, 27 Mic Models Model Based On* 57 Dynamic Shure ® SM57 409 Dynamic Sennheiser ® MD 409 421 Dynamic Sennheiser ® MD 421-U 30 Dynamic Heil Sound ® PR 30 20 Dynamic Electro-Voice ® RE20 121 Ribbon Royer ® R-121 160 Ribbon Beyerdynamic ® M 160 4038 Ribbon Coles 4038 414 Cond AKG ® C4…

43, 43 Global Settings > EXP Pedals Page Knob Parameter Description 1 1 EXP 1 Position Determines whether each expression pedal position is recalled per snapshot, per preset, or applied globally. If you want a Volume Pedal or Wah to maintain its position when switching presets, set this t…

34, 34 Tips for Creative Snapshot Use • The obvious use case for snapshots is designating them to specic sections of your song. For example, Snapshot 1 could be the Intro, Snapshot 2 might be Verse 1, Snapshot 3 might be the Chorus, and so on. • Turn any Delay, Reverb, and/…

23, 23 Volume/Pan Models Model Subcategories Based On* Volume Pedal Mono, Stereo Line 6 Original Gain Mono, Stereo Line 6 Original Pan Stereo Line 6 Original Stereo Width Stereo Line 6 Original Common FX Settings Parameter Description Drive Adjusts the amount of overdrive, distortion, or fuzz. B…

24, Line 6 HX Stomp 24 Amp+Cab Amp+Cab blocks are convenient in that when you select an Amp model, its match- ing Cab model is automatically loaded. It also only uses up one of the six available processing blocks. To change the amp model in an Amp+Cab block, press PAGE un- til the amp icon is bright red and tu…