Sentec tcPCO2 Instruction Manual

46, • Press or as many times as required to select the desired language. Note that changes do not become effective. • Press to confirm the selected language and to deactivate ‘editing mode’. To cancel changes and deactivate ‘editing mode’ press or . Note that upon deactiva…

50, 2011-07-01 15:28:30 7.7h 100% + - AD °C 41.9 RHP [Joe Miller] -/- Note: The operating status of the SDM’s auditory alarm signals is visually indicated by the ‘AUDIO STATUS Icon’ (p. 48), the ‘AUDIO PAUSED/AUDIO OFF Indicator’ (p. 45), and acoustically indicated by the ‘AUDIO OF…

24, Sentec tcPCO2 Check SDM Settings and System Readiness Before initiating patient monitoring, ensure the current SDM Settings/SDM Profile are appropriate for the patient, for the se- lected measurement site (p. 20), for the skin condition/skin tissue perfusion at the selected measurement site and for the spec…

15, Page 13 . Setting up the SDMS Installation of the Gas Bottle (Service Gas-0812) The gas bottle slot is located on the rear of the SDM 19 . Remove the old gas bottle by turning it counter-clockwise. Insert the new gas bottle by turning it clockwise approx. 4.5 turns and thoroughl…

8, In newborns PO 2 measured at the skin surface (PcO 2 ) correlates with arterial PO 2 (PaO 2 ) almost in a one to one relationship at a sensor temperature of 43 to 44 °C, whereby the accuracy of PcO 2 compared to PaO 2 is best up to PaO 2 of 80 mmHg (10.67 kPa), above whic…