SCINTEX BD150 Assembly Instructions Manual

8, Copyright (c) Scintex www.scintex.com.au [email protected] Page 8 Image 11 STEP 6 - Fitting Thermocouple The thermocouple has a bayonet style fitting. Screw the bayonet into the 3/4" tank fitting half way up the 200L tank. See Image 12. Then connect the thermocouple wire.…

3, Copyright (c) Scintex www.scintex.com.au [email protected] Page 3 STEP 2 - Hang the cone bottom tanks The 200L vessel will have been provided with the correct mounting bolts installed from the supplier. Use these bolts with spring washers to mount this vessel in the f…

1, Copyright (c) Scintex www.scintex.com.au [email protected] Page 1 www.scintex.com.au | [email protected] Model: BD150 Scintex Biodiesel Processor Assembly Instructions IMPORTANT: The process of making Biodiesel can release volatile gases (Methanol…

12, SCINTEX BD150 Copyright (c) Scintex www.scintex.com.au [email protected] Page 12 Diagram 1 - Schematic of hoses and kit components. …

2, Copyright (c) Scintex www.scintex.com.au [email protected] Page 2 STEP 1 - Frame Assembly The frame has been labeled in a method designed to make assembly straight forward. Steel should be arranged such that labels align AA, BB, CC, etc. See image 1 & 2. Bolts should …

5, Copyright (c) Scintex www.scintex.com.au [email protected] Page 5 STEP 4 - Install Tank Fittings Tank fittings are included in the kit and their mounting locations are as follows. Remember to thread tape all threaded fittings to ensure they won't leak. 2” Tank Fitting – bott…