Metrix Audio UTV 1 Installation Manual

1, Metrix Audio and Hogtunes Inc. are Owned by Powersports Audio Inc., Barrie, Ontario, Canada All Products Designed and Engineered In Canada UTV 1 Installation Manual Part # UTV 1 Manual (Rev A) Please take a few minutes and read this manual BEFORE starting the installa…

2, Metrix Audio UTV 1 Congratulations and thank you for your purchase of the Metrix Audio UTV 1 kit! Since positive word of mouth is the best way to grow our business, we want your new system to work as well as it was designed to. If you have any questions or concerns, we are here to help. Please email…

3, Blue: The Blue wire on the BT-1 will be connected to the blue wire on the Element X amplifier later on in the installation. The blue wire on BT-1 is the “remote turn on lead”. When BT-1 is turned on, the blue wire “tells” the Element X amplifier to turn on. Male 3.5mm: This is …

4, Getting Power to your amp: Plug the long harness with red, black, and blue wires into the mating 3 pin connector on the amp. Ground: The black ground wire must be properly connected to a good chassis ground. Poor ground connections are the cause of most amplifier failures! When an amplifier …

5, Speaker Placement: Take a few moments and hold a single speaker up to the machine so you can see a good place to attach them. As stated earlier, the speakers were designed in such a way that they could be mounted in front of the driver and pas…

6, Wiring the speakers: The speakers conveniently have 1 meter (3.3’) of wire coming out of each cabinet. The weatherproof connectors at the end of this wire will plug into the supplied 12’ (3.36m) as explained in the amplifier section of this manual. Once y…