OSO HOTWATER Super SC 120 Installation Instructions Manual

24, OSO Hotwater AS Industriveien 1 3300 Hokksund - Norway Tel: +47 32 25 00 00 [email protected] www.osohotwater.com © Alle deler av denne montasjeanvisningen er beskyttet av åndsverksloven og skal ikke reproduseres eller distribueres uten skriftlig avtale med produsenten. Forandringer forbeholdes. © Th…

21, - The Product has not been modified in any way, tampered with or subjected to misuse and no factory fitted parts have been removed for unauthorized repair or replacement. - The Product has only been connected to a domestic mains water supply in compliance with the European Drinking Water Di…

13, OSO HOTWATER Super SC 120 2 Port Valve (supplied) Mid Position Valve (not supplied) Pump flow Automatic bypass 6.5 Y Plan wiring layout A Honeywell 10 way Junction Box must be used in a Y plan system. No other wiring centre is acceptable. …

5, 5 1.2 Handling The product should be transported carefully with packaging as illustrated. Use the handle cut outs in the box ! Caution Tappings, valves etc. should not be used to lift the product as this may cause malfunction. Min. 400 mm 1.3 Clearances Min. 150mm …

15, 7.6 Service Procedure 8. Complete the service section of Benchmark/ Cylinder Commissioning Checklist included in the inside back pages of these instructions. 9. Remove , clean and replace line strainer. 10. The immersion heater element must be removed for inspection on service after 5 years. …