Opencockpits IOCard Displays II Manual 

8, IOCard Displays II Manual www.opencockpits.com 8 We need test if all 7-segment displays works fine, we will push ALL ON button that will put on all USB Expansion outputs, including our displays. If the displays doesn´t light on something is wrong and we have to revise all connections pi…

11, Opencockpits IOCard Displays II IOCard Displays II Manual www.opencockpits.com 11 -At the first IF condition we can see that switch connected to input "1", when is activated (value 1) sends to variable v0008 value 1 to activate the LED and send the desired values to the variable digits v0003, 4, 5, 6 &…

5, IOCard Displays II Manual www.opencockpits.com 5 To connect the 7-segment displays we can solder it directly, either throug pre-drilled cards or home made cards or Opencockpits PCB's (references 0T7, 0T6 y 0T10) and for that we can follow the next schemes: Displays dir…

4, IOCard Displays II Manual www.opencockpits.com 4 Connector's description: • J1 = INPUT DATA CONNECTOR FROM MASTER CARD. • J2, J3 ,J4, J5 = JUMPERS FOR DISPLAYS II IDENTIFICATION SELECTION. • SW1 = NOT USED. • J6 = 7-SEGMENTS OUTS. • J7 = COMMON CATHODE INPUTS. Inputs: …

3, IOCard Displays II Manual www.opencockpits.com 3 Introduction: The IOCard Displays II was specifically designed to use multi 7-segments displays at a time without having to use all Master's outputs and can facilitate the management, connections, configuration and exp…