OTO Machines BOUM Operation & User’s Manual

2, 01 BOUM USER MANUAL Safety warnings and recommendations Do not eat BOUM. Before using BOUM, make sure to read all the instructions below, and this User Manual. BOUM has some openings on its enclosure and 4 adhesive feet for cooling purpose. To ensure sufcient cooling, do not obstruct the o…

7, OTO Machines BOUM + 18 dB+ 6 dB IN GAIN This is the rst stage of the circuit. Raising the input gain also raises the compressor sensitivity. +12 dB0 dB 50 us 1 ms 10 ms In Gain Attack 330 us 3,3 ms 33 ms ATTACK Sets the attack time of the compressor. 10 11 …

8, RELEASE Sets the release time of the compressor. LO CUT This 6 dB/octave Lo Cut lter is located before the distortion. It can help make your distorted sound easier to mix with the original one. 12 13 500 ms 350 ms 1 sec100 ms 250 ms 50 ms Release 300 Hz75 Hz 150 Hz FLAT Lo Cut …

12, 2. MIDI FILTERS One of the IN GAIN, ATTACK or RELEASE switch is lit (the lter is off, BOUM will accept the corresponding MIDI message) or ashing (the lter is on, BOUM will ignore the corresponding MIDI message). The 3 MIDI FILTERS are: 1. Continuous Controllers (IN GAIN …

10, LOCAL MODE (MIX) Each Preset contains its own Mix value. Sometimes it can be useful to load a preset while keeping the current Mix settings. To change the Local mode, press and hold the RELEASE function key for at least 2 seconds. The RELEASE function key and one of the following LEDs …

11, EXIT WITHOUT LOADING OR SAVING A PRESET If you press the PRESET switch before selecting the bank or the preset, the preset won’t be loaded or saved. You can also wait 10 seconds. POTENTIOMETERS POSITION Once you recall a preset, the physical position of a pot may not be the same a…