Ralink WL-150G Operation & User’s Manual

8, 7 Figure 3-2 Link status 3.3 Site survey Site Survey tab shows that the connection status of the adapter. (If connected). See figure 3-3. SSID – Means the adapter is connected or will be connected, the right figure shows that the adapter is connected, SSID is the default network. BSSID –…

13, 12 Protocol (TKIP) and Advanced Encryption Standard (AES) FORBID – forbid the encryption function. WEP -- the shared key performs the encryption before data wireless transportation, you could communicate with the wireless devices which use the same shared key. TKIP --TKIP uses the stricter…

9, 8 Figure 3-3 Site Survey tab Rescan – make the adapter rescan the available device. If the link is not good or the signal is weak, the rescan will make the adapter link to a better device which will take several seconds. Connect – choose Network and click it to link from Netwo…

6, 5 Figure 2-4 Setup Finish 3. The use of utility This chapter describes how to configure your Wireless Adapter for wireless connectivity on your Wireless Local Area Network (WLAN) and use the data security encryption features. After Installing the Adapter, the Adapter’s tray icon will ap…

16, Ralink WL-150G 15 3.To configure the wireless connect properties, please right click the wireless icon in the tray and choose “Status”, open the page “wireless network link status”, see figure 4-3. Figure 4-3 Wireless Network Connection Status The page of“General” in Figure 4-3 displays link time,…

15, 14 4. Zero Configuration Right click the tray utility, and choose “Use Zero Configuration as configuration Utility”，and then Windows wireless network configuration could be used. See Figure 4-1. The windows wireless Network connection will prompt, choose the wireless net…