Ralink RT2880 Operation & User’s Manual

70, Ralink RT2880 RALINK AP SDK 3.3.0.0 User's Manual Page 70 of 93 15 64-QAM 5/6 6 108 6 1296 1080 270.0 300.0 2) EWC PHY spec. page 13. 3) EWC PHY spec. page 13. 11.12 How to build a single image for the flash programmer Example: Make a 4M single image for …

30, RALINK AP SDK 3.3.0.0 User's Manual Page 30 of 93 a. read: flash -r [offset(hex)] -c [num of bytes] b. write: flash -w [offset(hex)] -o [value(hex)] -c [num of bytes] c. erase: flash -f [first sector_num] -l [last sector_num Example: a. read: flash -r 370000 -c 4 …

23, RALINK AP SDK 3.3.0.0 User's Manual Page 23 of 93 5 TOOL-CHAIN The Ralink AP SDK uses buildroot to make the Linux kernel image. Buildroot is a set of Makefiles and patches. It is easy to make a cross-compilation toolchain and root file system for the target Linux system. Us…

79, RALINK AP SDK 3.3.0.0 User's Manual Page 79 of 93 Since the Intermediate Queueing (IMQ) pseudo device are used to support Ralink SW QoS, it must be enabled first, or some needed options in Netfilter configs won’t show up due to dependency. Networking ---> Device Driver…

39, RALINK AP SDK 3.3.0.0 User's Manual Page 39 of 93 dir_$(CONFIG_USER_HELLO_WORLD) += hello (f) Turn on hello application #make menuconfig [*] hello_world (NEW) (g) Build new image #make dep #make (h) check file is correct #cd RT288x_SDK/s…

41, RALINK AP SDK 3.3.0.0 User's Manual Page 41 of 93 3. Go out of the configuration menu and save the new kernel configuration. The script gets all user/kernel default settings back. The subsequent message is shown after getting the default settings back. *** End of Linux kernel conf…