Raychem TRACETEK TT5000-HS Installation Instructions Manual

8, 8 | nVent.com Complete System Connections and Layout A. TT500X-HS is available in bulkform, cut to length in the field and joined using connector kits–or it can be obtained in standard or custom cut lengths with connectors attached in the factory. Each cable has a female metal conne…

2, 2 | nVent.com 1 2B 2A Prepare the conduit and pull rope. • Verify that major construction is complete. • Verify conduit and pull rope has been installed properly. Reference TraceTek document H58175 for general information. Note that conduit dimensions and related parts can vary …

4, 4 | nVent.com 4 5 5A 5B Pulling the cable: • TT500X-HS sensing cable is sensitive to pressure from such things as pinches or tight corners. Cable stress, binding and kinking can result in cable damage and potential false leak detection signals. Take care during installation to maintain …

6, 6 | nVent.com 8 Take precautions if installation is incomplete at end of work day. At the end of the work day: • Ensure that there are no exposed connectors. Each sensing cable should be connected to a Modular Leader Cable (TT-MLC-MC), Modular End Termination (TT-MET-MC), and/or other sen…

5, Raychem TRACETEK TT5000-HS nVent.com | 5 Tape SCT SCT Unlabeled heat-shrinkable tube Adhesive visible at ends of tubing 65C 7 Prior to installing a new length of sensor cable, slide the unlabeled shrink tube (from connector kit) onto the cable. Connect the sensing cable to the cable circuit (lengths of sensing cable con…

10, ©2018 nVent. All nVent marks and logos are owned or licensed by nVent Services GmbH or its aliates. All other trademarks are the property of their respective owners. nVent reserves the right to change specications without notice. RaychemTraceTek-IM-H58740-TT5000HS-EN-1805 …