Motrona ZD Series Operating Instructions Manual

36, ZD340_07d_e.doc / Apr-17 Page 36 / 50 F10 Range Default Ser. 097 Switching characteristics K1 0 … 5 0 I4 0= active with display ≥ preselection 1= active with display ≤ preselection Remark : ≥ and ≤ refer to positive values and are inversely with negative values 2= act…

16, ZD340_07d_e.doc / Apr-17 Page 16 / 50 4.5. Evaluation of the Real Cutting Length: F07.062 = 4 This mode uses encoder 1 as a length counter and encoder 2 is not active. All counting occurs in the background and is not visible in the display. The counter gets started and stopped by remote cont…

49, Motrona ZD Series ZD340_07d_e.doc / Apr-17 Page 49 / 50 10. Dimensions Models ZD3xx and ZA3xx: 96,0 (3.780’’) 110,0 (4.331’’) 4 4 , 0 ( 1 . 7 3 2 ) 10,0 (.394) 8,0 (.315) 91,0 (3.583) 9,0 (.345) 129,0 (5.079) 140,5 (5.531) 4 8 , 0 ( 1 . 8 9 0 ) Panel cut out: 91 x 44 mm (3.583 x 1.732�…

20, ZD340_07d_e.doc / Apr-17 Page 20 / 50 The Start command can be assigned to any of the front keys or to or to any of the Control Inputs, by attaching the RESET function to it (e.g. set parameter F06.052 to 1 to assign the Start function to the ENTER key etc.). Also an automatic reset function with …

12, ZD340_07d_e.doc / Apr-17 Page 12 / 50 All operating modes provide separate impulse scaling factors for each of the two encoders. Please observe that the display of the counter will only show whole numbers (integers) whereas remainders will be carried in the background Example: Differential Counte…

30, ZD340_07d_e.doc / Apr-17 Page 30 / 50 6.2. Description of the Parameters 6.2.1. Preselections and presets F01 Range Default Ser. 00 0 Preselection K1 - 199 999 - 999 999 1 000 00 001 Preselection K2 - 199 999 - 999 999 2 000 01 002 Preselection K3 - 199 999 - 999…