TESA Auto lift system Installation & Operation Manual

16, TESA Auto lift system 16 AUTO (taste 3) After the phase START the automatic levelling can be started with the button AUTO . The jacks ascend to the ground and the control unit finishes the levelling. At any time two jacks are moving to share lifting power a…

14, 14 Control panel Description of LED’s 1. Red LED System on 2. Green LED ready for phase START 3. Red LED: ready for automatic levelling 4. Red LED: ready for manually levelling 5. Red LED ready for GET UP 6. yellow LED: button front jacks ac…

8, 8 Electrical connection of jacks Cable 1 must be connected to jack no. 1. Follow this procedure up to jack no. 4. Connect the wiring corresponding to the different colours. Pay attention to the optimal pass in order to keep the course of the jack. Choose the optimal way of fitting co…

20, 20 Warranty: In case of defects by legal using we guarantee for spare parts free of charge up to 2 years beginning from buying date. The manufacturer is not responsible for freights, times or other additional costs. The manufacturer is not responsible for damages caused by fals…

7, 7 Installation control unit The control unit is delivered ready pre-wired. Fit the box under the bottom of the vehicle at a center point in the middle. Following points are important for correct function: Electrical connection The cables on the control unit ar…

15, 15 Detailed description of functions In the following the several functions of the Autolift system are exactly described. Before using the system plead read this manual attentively. The below described functions are only available at ignition off. Nevertheless it is possible to use the mos…