Vernier Go Direct Photogate Manual 

7, 7 RF exposure warning: The equipment complies with RF exposure limits set forth for an uncontrolled environment. The antenna(s) used for this transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Le présent appareil est conforme aux CNR d’I…

5, 5 l Experiment: Explore conservation of momentum during collisions using two Go Direct Photogates (not daisy-chained). Sensor Channel: Object Velocity (on both photogates) Mode: Time-based l Experiment: Explore conservation of momentum during collisions using two daisy-chained Go Direct Photogat…

6, 6 If water gets into the device, immediately power the unit down (press and hold the power button for more than three seconds). Disconnect the sensor and charging cable, and remove the battery. Allow the device to dry thoroughly before attempting to use the device again. Do not attempt to …

4, 4 Photogate. When two Go Direct Photogates are daisy-chained together, you can connect either of the photogates to your device via USB or Bluetooth ® wireless connection. Once the first gate is connected, the second gate becomes the “Remote Gate” of the connected photogate. The Remote Gat…

1, Vernier Go Direct Photogate 1 Install Graphical Analysis 4 on your computer, Chromebook™, or mobile device. See www.vernier.com/ga4 for software availability. If using LabQuest 2, make sure LabQuest App is up to date. See www.vernier.com/downloads to update LabQuest App. Bluetooth Connection USB Connection 1. Cha…