ThermoTex Thermo-Ident 1 Operating Manual

21, Description of menu points GBTHIDBA_V(2).DOC Page - 21 6.30 Gluing Teflon The self-adhesive Teflon film on the heating element must be replaced in case of wear and tear. In order to glue the new Teflon film perfectly with the heating element, the film must be pressed down onto the heatin…

13, ThermoTex Thermo-Ident 1 General operation GBTHIDBA_V(2).DOC Page - 13 Figure 4-4 Permanent marking: Remove the locking pin from the opening on the hand lever. The heat-seal rubber is now held with a spring in an angled position (see figure 4-5). This means that the label is pulled a little to the left when hea…

10, General advice GBTHIDBA_V(2).DOC Page - 10 3.6 Materials and parameters It is important that the mould time, temperature and mould pressure are set correctly so that the labels glue well. The mould time and temperature can be set on the machine's control unit. • …

22, Label layout GBTHIDBA_V(2).DOC Page - 22 7 Label layout The Thermo-Ident can produce the following label types: • Plain text Any characters can be printed • Barcode 2/5 Interleaved (with/without plain typeface line) Lines that only contain 0…9 are printed as a barcode. If the…

8, General advice GBTHIDBA_V(2).DOC Page - 8 3 General advice 3.1 Transport Before transport, make sure that any parts of the machine that it is possible to touch have cooled down to room temperature! The mains cable, compressed air hose and data cable to the PC system must be removed for tr…