Setra Systems SRIM1 Operating Instructions Manual

10, 10 Fig. 3-8 Installed plugs on unused openings in the base. Connect the pressure tubes to the high and low pressure ports. Wire to the electrical terminals on the back of the housing. If desired, place electrical plugs on the unused holes in the base. Complete the installation by i…

14, 14 PASSWORD ADMIN Enables or disables the 4 digit numeric password, use backdoor password 0159, if the password is lost ZERO CALIBRATION “Tares” out any 0 pressure error. This must be done with 0 pressure applied. SPAN CALIBRATION “Tares” out any Span pressure error. This must be…

2, 2 Table of Contents 1.0 Introduction .................................................................................................................... 3 1.1 Intended use ...........................................................................................................…

15, 15 The Temperature and Humidity functions and alarming are only available on the SRIM2. TEMPERATURE FUNC Temperature Function, pressing the enter key will drop down into the setup of the external sensor for AN1 (Analog input 1). Press menu button to move between items in this menu. TEMP UNIT Pre…

17, 17 H_Max Vin Input the analog output of the humidity sensor corresponding H_ALARM ENABLE Enable or disable the Humidity alarms by using the down arrow to toggle between selections, Press Return key to accept selection RETURN Returns from the conguration mode to the nor…

8, Setra Systems SRIM1 8 Terminal Function EXC +24 VDC supply COM Power supply COM and analog out COM VOUT Analog output + (VDC mode) mA Analog output (mA output mode) D1 Door status, wire to one side of NO contact D_COM Door status, wire to other side of NO contact D12 Not used AN1 + output of temperatu…