Torbal AGC100 Instruction Manual

34, Instruction Manual - TORBAL AGC Series (E) Percent Weighing 1. To enable percent weighing, press the “T” (YES) key when Percent is displayed 33 Table 7.1.3.D: Display Hold Operating Modes Automatic Display Hold initialization: Automatic Result Clearing: Automatic Tare: Automatic When set to…

47, Instruction Manual - TORBAL AGC Series 7.1.6.3. Printout Receipts After completing a weighing transaction, result data receipt may be printed. To initiate printing, wait for the weighing result to stabilize and press the “P” key. Note: Examples below include GLP data. For more on GLP printin…

23, Instruction Manual - TORBAL AGC Series 5. When the desired setting is displayed press the “Function” key to accept and save the selection. The scale will return to the Calibration Menu. To exit the Menu, press the C key. 7.1.2. Units of Measure Selection TORBAL AGC series sc…

42, Instruction Manual - TORBAL AGC Series 9. To enter an ID or a number, use the following keys: 0(NO) to increment a digit, “T” (YES) to accept and go to the next digit, “Function” to accept the entire setting, and “C” to clear and start over. To become familiar with e…

21, Torbal AGC100 Instruction Manual - TORBAL AGC Series 3. A dash will appear on the display indicating to enter a desired time interval. The time interval can be set between 1, 2, 3, 4, 5, and 6 hours (i.e. if set to 3, calibration will be performed once every 3 hours). 4. To set a calibration time…

16, Instruction Manual - TORBAL AGC Series 5. Before calibration begins, the scale will perform automatic tare. TARING will be displayed during auto tare. 6. Once the scale tares, command “LOAD C” will be displayed, followed by “C” indicating that automatic calibration is in progress. 7. Ca…