Shiseido Handy Skin Sensor II Instruction Manual

14, Shiseido Handy Skin Sensor II LED lamp 3. Charging Sensor 1. Slide Sensor in from the top of Sensor stand to place it properly. Caution Sensor will not charge if it is placed in a wrong direction or not set in place properly. 2. Sensor stand will charge the battery inside Sensor. LED lamp indication Charging － LED…

11, *Do not lose any parts including the packaging box. Ⓐ Connector for Sensor stand Ⓑ Connector for AC adopter *Use when you connect the cable to Sensor stand. Ⓐ Connector for Sensor Ⓑ Connector for the designated device *Use when you connect Sensor to the designated device. Contac…

17, Be sure to insert rechargeable battery to the battery compartment with triangle mark on battery matches to the same mark in the housing as shown. Also, you may find slotted groove on the left side on the battery. Fully insert Rechargeable battery. Follow the direction 1 in reverse orde…

18, ◆ Troubleshooting Sensor Symptom Solution It does not turn on. Check • Is Rechargeable battery correctly inserted to Sensor? • Is it charged? Solution • Change to charged Rechargeable battery. • When you turn it on, press down on Power switch for 2-3 seconds. The…

10, (Front) (Back) Cable guide Skin tone calibration plate Skin tone calibration plate RGB Value USB connector (With Skin tone calibration plate cover open) (Seen from the top) Serial number Battery slot Skin tone calibration plate LED lamp Serial number Close-up *Serial number and …