Atlantis Land Mistral Lan Router ISDN Command Manual

29, show ip Description: This command displays all interfaces on which IP routing has been enabled. Example: Router> show ip Admin. Oper. Destination/ IfName State State IP Address Netmask Broadcast Addr ------------------------------------------------------------------- ppp2 E…

48, show telnet session Description: This command is used to display all existing telnet sessions. Example: Session Id Remote IP Remote Port ----------------------------------------------------- 1 204.71.212.38 2052 2 204.71.212.39 2564 show time Description: This command shows the …

35, Existing profiles are edited also using the “add profile” command. In this case, the defaults shown are the existing configured values. πThis router only support one profile over EWAN interface. When an ewan profile is configured, the following new added profile(s) will select ISDN auto…

12, Atlantis Land Mistral Lan Router ISDN reset system save config set console baud <baudrate> set console timeout <timeout value, 1- 60> set date <mm-dd-yy> set daylight time <on/off> ⊕set internet access time set log level <1-10> set prompt <string up to 15 characters, inclusive>…

16, 255 ≥ xx ≥ 0 255 ≥ xx ≥ 0 Once configured, the DHCP server will assign private addresses from within the defined private address range with the highest available address being assigned first. This address range may be modified using the “set range” command. Statically assigned addr…

32, disable port <port name> enable port <port name> Description: These two commands is used to disable or enable a port. ⊕set port <port name> The set port command is used to initialize or modify the characteristics of a hardware port on your router. Hardware ports are id…