ProSun RenuvaSkin JD 3200 Operation & User’s Manual

27, 27 A B C D E F Display messages: Reading Hour Counter: Hour counter lamps x 10 Reset hour counter lamps Overrule error (Switch print and/or display print defective) Hour counter red light bed x10 (not able to reset) Filter glass defect (Filter …

11, 11 Flip bench over. Retrieve 2 Combi Arms 6 Combi Arm Screws Remove the end cap ller. Insert combi arm into bench and secure with screws. Repeat these steps on other side. 3 4 1 end cap llerbench combi arm …

20, 20 Unscrew and remove top. Pin 1 neutral Pin 3 live 1 2 Optional T-Max Connection If you are adding a T-Max timer to your unit follow the steps below. * For commercial use only Remove the male end from the female (located on the back of the canopy) Back of canopy Male Female …

14, ProSun RenuvaSkin JD 3200 14 Retrieve 2 Gas shocks 4 Gas shock pivots 4 security clips While the canopy is in an open position, insert gas shock into the bench and into third hole on the canopy. Then insert gas shock pivots and secure with a security clip. 7 If the canopy rises spontaneously move gas shock t…

16, 16 *Optional Deco Shield Retrieve 1 Deco shield 2 deco shield screws 2 deco shield washers 2 deco shield nuts Insert the deco shield in between the canopy and bench. 7 Secure by attaching the decor shield to combi arm. 8 screw washer nut …

10, 10 Carefully remove the bench from box and keep it face down. *Optional Front Skirt (if you do not have a plastic front skirt go to step 3) Retrieve 1 Plastic front skirt (located in canopy box) Remove the screw from the leg. Insert plastic front skirt and screw in place. Repeat these steps o…