Vivotek AM-518 Operation & User’s Manual

6, 6 Hole marked as D+ Due to its unique mechanical design, the mounting procedure for an FE8171V sheye camera is specically described as follows: 1. Remove the camera's top cover. 2. Fasten 2 included screws to the D holes (not the D+ hole). 3. Align the camera with the mounting adapte…

3, Vivotek AM-518 3 English Compatible Accessories (1): AM-311 Pole Mount Bracket Compatible Accessories (2): AM-411 Corner Mount Bracket Compatible Accessories (3): AM-711 Junction Box Compatible Accessories (4): AM-212 Wall Mount Bracket Compatible Accessories II …

5, 5 English Mounting & Cabling III Above are the locations of different groups of mounting holes for matching different cameras: Hole Type Applicable Cameras A FD8362E, FD8362, FD8361, FD8335H, FD7141, FD7141V, and FD8372. B FD8161, FD7131, FD7132 C FD8162, FD8135H D FE8171V A…

9, 9 English 307 mm 115 mm 178 mm 1 Below is a sample procedure using a Pendant pipe: 1. Determine a hard surface ceiling location, and use the four mounting holes on the pendant head to mark the positions where holes will be drilled to secure the pendant head. Note that screws are user-…

8, 8 Below is a closer view on routing cables and matching a mounting plate. Wall Mount Bracket Mounting Adapter Cables FD8362E Mounting Plate NOTE: Use the correct type of screws when installing cameras to the mounting adapter. Refer to page 5 for the screw type. The sample mounting p…

10, 10 2 4 5 3 7 6 8 2. Locate the position where you want to install the pendant pipe and camera. Drill holes on the ceiling for securing the pendant head. Secure the pendant head by hammering anchors into the ceiling and then fasten screws through it. 3. Route power lines and other cables …