Signstek FF-003 Operation & User’s Manual

15, Signstek FF-003 13 In each menu tab use the Down or Up Key to select a specific menu item, and use the Left or Right Key to change a menu setting, then press the View/Esc Key to return to the top until close menu system. Sensitivity Settings: "Auto", "1%" to "100%…

16, 14 Select "Auto" to have the unit automatically select the Depth Range, the bottom signal is automatically placed in the lower half of the screen. Select specific value to locks the depth range to a specific setting. NOTE: In manual operation, if t…

8, 6 Key Functions Zoom Key View/Esc Key Menu Key Arrow Keys Power Key (Up/Lower/Left/Right) Power On/Off Press and release Power Key to power the unit On, the Loading Page is displayed first. After a few seconds the unit start to work. Press and hold P…

29, 27 Place a small amount of liquid water on the ice and set the sonar sensor on the water allowing the unit to freeze to the ice. If there are any air pockets between the sonar senor and ice, or air on the water below the ice, the unit will not work properly and will…

7, 5 Installing the Batteries When you first use the Fish Finder you will need to install the batteries. Slide the battery door and insert 4 "AAA" batteries to the battery compartment. Be certain to align the batteries as per the diagram within the batter…

22, 20 Volume Settings: "High", "Medium", "Low" Volume setting allows you to adjust the Alarm Volume so that you can select the tone that you can hear best. Keel Offset Settings:"Off", "-9ft" to "+9ft" ("-3m" to "+…