ATN NVG-7 Operator's Manual

54, B-4 NOTE Confirm the image intensifier is out of the warranty period before replacing the image intensifier. If in the warranty period. If not in the warranty period. C-2. REMOVAL 1. Remove objective lens. CAUTION Handle image intensifier gently to prevent damage. Set …

37, 3-3 3.1.2. EDGE GLOW Edge glow is a bright area (sometimes sparkling) in the outer portion of the viewing area (Figure 3-2). To check for edge glow, block out all light by cupping a hand over the lenses. If the image tubes are displaying edge glow the bright area will still show up. Con…

48, 4-8 2. Replace the chinstrap by using the Velcro tape on the left side of the headband. Lace the right straps into their respective sliding bar buckles on the right side of the headband for correct lacing (Figure 4-2). 4.4.3. REMOVAL AND INSTALLATION OF CHIN CUP 1. Remove the …

12, 1-6 C. Principle of Operation The NVG-7 Night Vision goggles utilize the principle of intensification of the residual light which is reflected from the surrounding objects. The device consists of the objective lens assembly, eyepiece and the body. The body contains a image inten…

4, b EQUIPMENT LIMITATIONS To avoid physical and equipment damage when using the ATN NVG-7, carefully read and understand the following equipment limitations. …

17, ATN NVG-7 1-11 TABLE 1- 5. NVB5X KIT ITEM DESCRIPTION QTY 1 5X Lens 1 2 IR450-B4 Illuminator 1 3 CR123A type battery 1 4  1 5 IR450 Wrench 1 6 Mil-spec hard case 1  is shown in Figure 1-5 and listed in Table 1-6. FI…