V-ZUG REFRESH-BUTLER Operating Instructions Manual

22, 5 Programme overview 5.1 Main refreshing programme With the main refresh programme your dry clothes are freed of odours and germs using steam and heat. The main refresh programme has 3 phases: Refreshing The heater heats up the circulating air temperature and the washing is dampened u…

61, 11 Technical data 11.1 Consumption data for factory setting D = Duration E = Energy T = Temperature F = Fresh water consumption R = Relative moisture Programme D [mins.] T [°C] R [%] E [kWh] F [g] Refresh - - - 0.6 300-600 Heating up about 15 40 - - - Steaming 44 45-50 70-80 - - Drying about 10…

6, 1 Safety precautions 1.2 General safety precautions • Read the operating instructions before using the appliance for the first time! • This appliance can be used by children aged 8 and above and by persons with reduced physical, sensory or mental capabilities, or lack of experience and/or k…

34, 6 User settings 6.8 Descaling Whenever steam is produced, depending on the hardness of the local water supply (i.e. the limescale content of the water), limescale is deposited in the boiler. The appliance automatically detects when descaling is necessary. The time interval between descaling…

27, 5 Programme overview Load • Full For a maximum 5 kg dry load spread out on the upper and lower clothes rails. • Half-full For a normal load spread out on the upper and/or lower clothes rail. • Small For a small load, e.g. 4 shirts. Easy care • Very gentle programme with reduc…

26, V-ZUG REFRESH-BUTLER 5 Programme overview The following diagram gives an overview of the programme settings in the ex- tra programme drying. Normal dry * Extra dry Load Easy care Level of dryness Timed drying Delayed start * Factory setting Full Half-full * Small 30 40 50 60 90 120 Off * Yes No * Level of dry…