UTAH SCIENTIFIC SCP Series Operation & User’s Manual

159, SCP Series • User’s Guide 7-29 Monitor Matrix Mode Chapter 7 6. Select the Monitor Matrix destination — using either the direct, numeric, or mnemonic methods. Refer to the “Selecting a Destination” section on page 7-9 for instructions. The Destination Display label reads “MMTRX.”…

162, 7-32 SCP Series • User’s Guide SCP SX/16 Operations Storing a Direct Breakaway Source Use the following steps to store a direct breakaway source in one of the 16 available “direct source” registers. 1. Use the Display Type button to select the numeric or mnemonic mode as desired…

202, 8-24 SCP Series • User’s Guide SCP MX/16 Operations 5. Select a destination in the normal manner. Refer to the “Selecting, Storing and Clearing Destinations” section on page 8-13 for instructions. 6. In the Select Section, press the Select buttons for the levels that you…

99, SCP Series • User’s Guide 6-5 About the SCP XY/16 Chapter 6 • The eight Source Level Status Displays provide status for up to 16 levels. Each display is an eight-segment LED readout that shows the current source associated with that level, in either the numeric or mnemonic (…

47, UTAH SCIENTIFIC SCP Series SCP Series • User’s Guide 3-7 Performing an All-follow Take Chapter 3 3. Press the Destination Select button to choose the desired destination. 4. Press the desired Direct Source Select button. Figure 0-5. Direct Source Select Section The button lights, the source is automati…

100, 6-6 SCP Series • User’s Guide SCP XY/16 Operations Pressing the Salvo button on the SCP XY/16 panel allows you to run one of 32 pre-defined command lists. The panel simply chooses the Salvo number and issues the “Take” command. Refer to the “Performing a Salvo Take” section on pag…