Upright X20N Operator's Manual

14, Page 12 114110-000 X-Series - Operator Manual Transporting the Machine D RIVING OR W INCHING ONTO A T RUCK OR T RAILER WARNING ! ! Never winch faster than 0,3 m/sec. ( 1 ft./sec. ). Never operate the machine with the parking brakes released. Serious injury or damage could result. 1.…

12, Upright X20N Page 10 114110-000 X-Series - Operator Manual Operation P ARKING B RAKE R ELEASE Perform the following only when the machine will not operate under its own power and it is necessary to move the machine or when winching onto a transport vehicle (see “Transporting the Machine” on page 11…

19, Daily Inspection and Maintenance Schedule 114110-000 X-Series - Operator Manual Page 17 D AILY I NSPECTION AND M AINTENANCE S CHEDULE The Complete Inspection consists of periodic visual and operational checks, along with periodic minor adjustments that assure proper performance. D…

10, Page 8 114110-000 X-Series - Operator Manual Operation G UARDRAILS , X20N – X26UN Figure 5: Guardrails The guardrails may be lowered for the purpose of passing through a standard doorway. Guardrails must be returned to proper position before using the machine. WARNING ! ! DO NOT use …

17, Maintenance 114110-000 X-Series - Operator Manual Page 15 H YDRAULIC F LUID The hydraulic fluid reservoir is located in the control module door. Figure 11: Hydraulic Fluid Reservoir and Dipstick NOTE: Never add fluid if the platform is elevated. C HECK H YDRAULIC F LUID 1. Make sure…

9, Operation 114110-000 X-Series - Operator Manual Page 7 E LEVATING THE P LATFORM 1. Locate a firm, level surface. 2. Check clearances above, below, and to the sides of platform. 3. Turn the Lift/Drive Switch to LIFT. 4. While engaging the Interlock Switch, push the Control Handle FORWA…