Unitech RP901 Operation & User’s Manual

74, RP901 User Manual 3.13 Vibrator Enable or Disable the Vibrator which may be used to signify a Good Read during a Scan Operation. Configuration Method: Choose one of the options, then click to transfer the parameter setting to the RP901. Default Setting: Disable (deacti…

71, RP901 User Manual 3.10 Data Terminator Set the terminator symbol used when uploading RP901’s data to the Host-PC. It can be 1 or 2 Bytes depending on the Communication Interface. Configuration Method: Choose or type in a symbol using the special keyboard shown in photo. S…

67, Unitech RP901 RP901 User Manual 3.7 Memory Communication Interface Options When the Memory Communication Interface is chosen, each scanned data is marked with date and time, and then stored in the internal memory. When the memory is full with data, Tag reading will elicit a warning signal in the…

42, RP901 User Manual 3.1.1 Operation Mode Configure the Operation Mode for either Trigger Mode or Auto Mode. Configuration Method: Select one of the two options then click to send the new parameter to the RP901. Default Setting: Trigger Mode Detailed explanations of Trig…

60, RP901 User Manual 3.5.8 CRC (Cyclic Redundancy Check) Whether to output tags’ CRC value. This function is available when the EPC Code of Tag Info is selected. Configuration Method: Choose Disable or Enable. Default Setting: Disable If Output CRC value is enabled, the following …

44, RP901 User Manual 3.1.2.2 Sessions and Target Session and Target can be set for determining how often a tag will respond to a query from the reader and allowing for multiple readers to conduct independent inventories. ￭ Session There are four Sessions,S0,S1,S2…