Unitech MS916 Operation & User’s Manual

46, - 30 - 3.1.14 UPC-A Preamble Preamble characters (Country Code and System Character) can be transmitted as part of a UPC-A symbol. Select one of the following options for transmitting UPC-A preamble to the host device: transmit system character only, transmit system character…

79, - 63 - 3.10.3 MSI Check Digits These check digits at the end of the bar code verify the integrity of the data. At least one check digit is always required. Check digits are not automatically transmitted with the data. If two check digits are selected, also select an MSI…

16, xiv © 2015 unitech Electronics Co., Ltd. All rights reserved. unitech is a registered trademark of unitech Electronics Co., Ltd. 3.7 Discrete 2 of 5 ......................................................................................54 3.8 Chinese 2 of 5 ..........................…

65, - 49 - • Length Within Range - Select this option to decode a Code 11 symbol with a specific length range. Select lengths using numeric bar codes beginning on Appendix B. For example, to decode Code 11 symbols containing between 4 and 12 characters, first scan Code 11 - Length Within …

113, Unitech MS916 - 97 - Appendix A –Miscellaneous Code Information AIM Code Identifiers Each AIM Code Identifier contains the three-character string ]cm where: ] = Flag Character (ASCII 93) c = Code Character (see Table A-2) m = Modifier Character (see Table A-3). Table A-1 Code Cha…

11, ix © 2015 unitech Electronics Co., Ltd. All rights reserved. unitech is a registered trademark of unitech Electronics Co., Ltd. Storage and safety notice Although charged batteries may be left unused for several months, their capacity …