UnionSpecial 60000 D Manual, Instructions For Adjusting

5, T)ie hook should also be set later ally so there Is approximately .003 inch to .005 inch clearance between the spot in the needle and the point of the hook (Fig. 3). This is done by loosen ing set screw (A, Fig. 1) and moving the hook to the left or to the right as may be required …

3, UnionSpecial 60000 D ADJUSTING INSTRUCTIONS FOR STYLE 60000 D DESCRIPTION OF MACfflNE 60000 D Flatbed, single needle, chain stitch Type 101, for closing small filled paper bags on Style 21800 N, with two paper reinforcing tapes, one guided next to presser foot and the other next to feed dog, seam Type …

16, TAPE GUIDES The lower tape guide must be set so that the delivery end fits up against tape opening in the throat plate. The tape should then slide from the guide into the throat plate in one continuous motion until it contacts the presser foot. The setting of the upper tape guide is…

13, PRESSER BAR HAND LIFTER Assemble the presser foot to the presser bar. Turn handwheel so the feed dog Is In Its lowest position. Set presser bar connection (A, Fig. I4) so there is 3/32 inch clearance between it and the hand lifter. PRESSER BAR Set the lower presser spring collar (B, Fig.…

18, The amount of grease In the gear housing should be checked semi-annually to keep gears well lubricated. If more Is necessary^ refill with grease similar to a commercial No. 3. The correct application of good quality oil and grease will add years of service and trouble free operation. FEED TIMING T…

11, The height of dog (F, Fig. 12) is properly set hy ad justing screw (C) against stop pin (D) until the point of the dog (F) is flush with the top of the lever extension (G). This adjustment and the one in the preceding paragraph may seem to conflict. However, by working these two adjustments tog…