Trapeze Mobility Point MP-122 Installation Manual

8, Documentation Trapeze Mobility Point Installation Guide 2 Documentation Consult the following documents to plan, install, configure, and manage a Trapeze Networks Mobility System: z Read me first: z Trapeze Regulatory Information. Important safety instructions and compliance information that…

11, Chapter 2: MP Overview 5 Chapter 2 MP Overview A Trapeze Networks Mobility Point (MP) access point provides 802.11 wireless access to the network. MP access points are designed for use with a Trapeze Networks Mobility Exchange (MX) switch. MP access points require hardware installa…

27, Trapeze Mobility Point MP-122 Chapter 3: Installing an MP 21 Installing an MP 7 Pull the Cat 5 cable(s) about 15 cm (about 6 inches) through the hole in the ceiling tile to create enough slack to insert the cable(s). 8 Insert the Cat 5 cable(s) into the connector(s): z For a single connection, use either connect…

31, Chapter 3: Installing an MP 25 Installing an MP Figure 23. Step 9—locking the bracket 10 To ensure that the MP access point is fully locked onto the bracket, gently pull down on the access point and attempt to rotate it from side to side. If the access point comes off the bracket, relock …

16, Connection Options Trapeze Mobility Point Installation Guide 10 z Dual-homed connection to two MX switches In dual-homed connections, both paths can be used to exchange control information but only one path is used for data. Spanning Tree Protocol does not run on an MX switch port con…