WABCO IVTM Instructions For Installation Manual

12, 13 The system may be extended up to 12 wheel modules for one control unit. Performance of the system may be checked by internal diagnostics memory. 2.1.3 Display All necessary information of IVTM system is shown on display. Connected to particular control unit by CAN bus. These data are amon…

1, Integrated Vehicle Tire Pressure Monitoring Vehicle tire pressure monitoring system System functions System configuration Instructions for installation and diagnostics 1st. edition 815 000 452 3 8150004523 Revisions of this document are not set up. New versions could be found in INFORM website w…

6, WABCO IVTM 7 This requires using sophisticated evaluation algorithm, instead of using simple identification of limit value. Other requirements for tire pressure monitoring systems of utility vehicles: • exact wheel identification for vehicles with more than 10 wheels or with double wheels…

3, 3 1 Contents 1. System functions 5 1.1 System structure 7 1.1.1 Example of installation in the bus 8 1.1.2 Example of installation in the trailer 8 2. Configuration 9 2.1 Components 10 2.1.1 Wheel module 10 2.1.2 Electronic control unit (ECU) 12 2.1.3 Display 13 2.2 Wiring 14 3. I…

29, 30 Action: Drive should slow down the vehicle and on first occasion adjust the tire pressure. 4.4.3.5 High pressure This defect could be found only for cold tires, i.e. if the vehicle stand for more than four hours with ignition switched off. In this case the defect is displayed two minutes after t…

27, 28 Example: If the three axles trailer is connected to shown vehicle, Fig. 3 is changed to: The display shows IVTM logo (Fig. 2) and stays without change till the button is pressed or the defect is found. If the defect is found on one of the vehicle wheels, symbol of particular wheel…