Sonomed 300P Instruction Manual

32, Section 4 Pachymeter Operation and Clinical Use MEASUREMENTS – MULTIPLE READINGS SINGLE POINT 1. Make certain the probe tip is clean & dry. 2. Place the probe tip onto the cornea starting at the optical center, making certain that the probe tip is perpendicular to the surf…

36, Sonomed 300P Section 5 Maintenance and Service Section 5 MAINTENANCE AND SERVICE The maintenance described below should be performed routinely so that the P ACSCAN™ is always operating in a safe and reliable manner. In some cases (calibration check, probe examination et…

27, A-Scan Operation and Clinical Use Section 3 scan. In such a case, a scan may have to be accepted based on its meeting the remaining criteria. EXAMINATION MODES Before performing an axial length measurement the user should always verify the operating mode (cataract,…

5, ii Doc # 0300-A-1901-3D 3.5 PATIENT EXAMINATION 3-4 Direct Contact Scanning in Automatic Capture Mode Direct Contact Scanning in Manual Mode Water Immersion Technique Performing IOL Calculations Printing 3.6 SOURCES OF ERRORS AND HOW TO 3-11 AVOID THEM Corneal …

37, Maintenance and Service Section 5 should be protected from temperature extremes and humidity which can cause condensation within the unit. The probes should be removed from the P ACSCAN™ and stored where they will be protected from damage. PROBE GENERAL INSPECTION 1. The probes …

24, Section 3 A-Scan Operation and Clinical Use desired, they may all be deleted by touching the [ CLR SCANS ] button. 10. Remove Prager Scleral Shell. Once all desired scans have been captured, raise the upper eyelid to release the top portion of the shell from under the eyelid. …