Simex SWE-73-L Operation & User’s Manual

28, User manual - METER SWE-73-L Figure. 9.4 Example of user defined characteristic 9.2. EXAMPLES OF CALCULATIONS Example 1: Selection of the permissible input range (“4-20” mode) If the user sets “Lo r” = 20,0% and “Hi r” = 10,0%, then permissible input …

29, User manual - METER SWE-73-L a) I in =10 mA and I n = 0,375 Accordingly to expression on page 26 for linear characteristic: 0,375 × [1200 -(- 300)] @ 562 and next, the “Lo C” value is added to the result , so the displayed value: W @ 562 + (-300) = 262 b) I in = 2,5 mA and…

22, User manual - METER SWE-73-L The permissible range allow user to exceed the nominal range of input signal. If input value is contained in the permissible range a proper result is displayed. If input signal exceeds this range (defined by “Lo r” and “Hi r” ), “-Lo-” or …

8, Simex SWE-73-L User manual - METER SWE-73-L 4.3. CONNECTION METHOD Caution - Installation should be conducted by qualified personnel . During installation all available safety requirements should be considered. The fitter is responsible for executing the installation according to this manual, loc…

6, User manual - METER SWE-73-L 4.1. UNPACKING After removing the unit from the protective packaging, check for transportation damage. Any transportation damage must be immediately reported to the carrier. Also, write down the unit serial number on the housing and report the dama…

31, User manual - METER SWE-73-L 10. DEFAULT AND USER'S SETTINGS LIST Parameter Description Default value User's value Desc. page Parameters of relay R1 operation (“rEL1” menu) SEtP Relay R1 threshold 20.0 18 SEt2 Relay R1 second threshold 30.0 19 HYSt Hysteresis of relay R1 0.…