YI Technology YI Halo Operation & User’s Manual

46, ! 45! 4.5.2 Jump Manager Jump manager is a Mac-only desktop application that is the interface between the YI HALO and Jump Assembler. Jump Assembler is a cloud-based system for converting the raw footage captured by a Jump compatible camera into a VR video. To learn more …

55, ! 54! SD Card Format Not Supported - Re-insert the microSD card and reboot the rig. - If the problem still exists, switch the microSD card with microSD card from another unit camera and reboot the rig. - If the problem still exists, format the microSD card with a YI HA…

59, YI Technology YI Halo ! 58! 4. Power on the rig by long pressing the shutter button and see if the issue is fixed. 5. If the issue still exists, check if it a problem with the same unit camera or with the known good camera. If yes it is the same camera, the unit camera itself might be broken; please r…

41, ! 40! ● Side view which shows full height previews side-by-side with horizontal drag to pan, so you can see more details. …

36, ! 35! 3.4.2 Screen Brightness You can customize the brightness of the screen by tapping the ‘Brightness’ bar and select between High, Middle and Low. 3.4.3 Screen Auto Sleep If you turn the ‘Screen Auto Sleep’ on, the screen will automatically turn off after one minute of i…

23, ! 22! Note: ● Be sure to line up camera 1 with the top ring marked 1. Camera 1 is unit camera directly above the controller. You can refer to the photo below, there is “1” mark on the ring and over the controller. ! ! ! ! ● Replacing the up camera 1. Remove the up camera’s pan…