XAC RP-10 Installation Manuals

1, XAC RP-10 d I NS T RT O T ALLATI O O S PAYM E RP - 1 O N G UID E E NT DEVIC E 10 E E …

2, 1. PACKAGE CONTENT 2. DEVICE OVERVIEW RP‐10 Key Buttons & Interface Ports (Figure 1): Figure 1 FRONT AREA 1 2.4” Display 2 Rubber Keypad 3 Magnetic Strip Reader (MSR) slot 4 Smart Card Reader (SCR) slot REAR AREA 5 USB cable (type A) 6…

3, ■ RP-10 power spec: Input: 5V DC, 0.5A  Operating Temperature: 0 o C to 40 o C 3. POWER ON/OFF THE DEVICE To power on the device, please plug the USB cable into the USB port of your host terminal or POS. Note: When there is no action on RP‐10 after 60 seconds, th…

4, 6. USING THE KEY PAD After inserting the chip card, Press the numeric key as below keypad (Figure 6) to enter the desirable numbers. Press Cancel (X) key to terminate any current function and press the Enter (O) key to confirm a value or an option. Figur…

5, Figure 10 FEDERAL COMMUNICATION COMMISSION INTERFERENCE STATEMENT This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received,…

6, The above information is the exclusive intellectual property of XAC Automation Corporation and shall not be disclosed, distributed or reproduced without permission of XAC Automation Corporation. XAC Automation Corporation 886-3-577-2738 …