Xforce Flareforge FF-1 Original Instructions Manual

3, 44 5 FF-1FF-1 WORK AREA AIR SUPPLY MAINTENANCE PARTS LISTING PRECAUTIONS SAVE THESE INSTRUCTIONS • Keep a clean and well-lit work area. • Keep FlareForce™ out of the reach of children. • Use a clean, moisture-free, well-lubricated, air supply at 90 psig (6.2…

5, 88 9 FF-1FF-1 6.1 6.2 3/16" STAGE 2 DIE 1/4", 6MM, 5/16", 3/8" STAGE 2 DIE FRONTFRONT BACKBACK 2. Remove (2.2) Taper Ring, (3) Jaw Holder and (4) Jaw Set from chuck. 3. Place the correct size (4) Jaw Set for the tubing you are flaring into the correct (3) Jaw Holder, ma…

4, Xforce Flareforge FF-1 66 7 FF-1FF-1 2. Retainer Assembly 4. Jaw Sets 4. Jaw Sets 3. Jaw Holders 5. Stage 1 Dies 2.1 4.3 4.1 3.1 2.2 4.4 4.2 3.2 RETAINER NUT 5/16" JAW SET 3/16" JAW SET 3/16" JAW HOLDER WITH SPRINGS TAPER RING 3/8" JAW SET 1/4" (6MM) JAW SET 1/4", 6MM , 5/16",…

1, C-1210 REV A FF-1 ORIGINAL INSTRUCTIONS TRADUCTION DES INSTUCTIONS ORIGINALES ÜBERSETZUNG DER ORIGINALANLEITUNGEN TRADUCCIÓN DE LAS INSTRUCCIONES ORIGINALES EN FR DE ES …

7, 1212 13 FF-1FF-1 ENEN CREATING A SINGLE FLARE 1. Attach air hose to connector at bottom of tool handle. 2. Make sure (7.1) Die Slide is in place by pushing from left side all the way to right position. (7.1) Die Slide should protrude from right side of tool as shown with circular…