MYERS ME3F Series Installation, Operation & Parts Manual

6, 6 Minimum sump Diameter 12” 10-1/2” Min. 14” Min. 7 to 8” 12 to 13” Bottom of Inlet Pipe Start Level Stop Level 1-1/2” Shut-Off Valve 1-1/2” Check Valve with Rubber Sleeve Connectors 4 Ft. Min. Grounded 115 or 230 Volt Outlet Not To Scale Float Switch Lifting Ring Sum…

3, MYERS ME3F Series Hazardous voltage. Can shock, burn or kill. DO NOT remove the grounding pin from the power cord. Avoid using extension cords or 2-prong adapter plugs. Insert the piggyback plug that comes from the float switch directly into the power receptacle. Insert the pump power cord directly into the back of…

2, PERFORMANCE INSTALLATION Hazardous voltage. Can shock, burn or kill. Do not lift pump by the power cord. See “Cord Lift Warning” below. NOTICE: Install the pump on a hard, level surface (cement, asphalt, etc.). Never place the pump directly on earth, clay or gravel surfaces. Install the pump in…

7, 7 45° Control Mounting Bracket (SST) Rail Support Junction Box Structural Plastic 30” Dia. Basin Cover Valve Extension Handle 6” 18” Lift-Out Rope As Req’d. As Req’d. As Req’d. 1-1/2” Discharge, Effluent Inlet Hub (As Req’d) ME3H/ME3F Automatic Effluent Pump 30” Dia. …

5, 1. Remove the oil fill plug located on top of the motor housing and drain the oil in the housing. NOTE: Dispose of the oil according to ordinance. Do not reuse the oil since it may contain water from seal failure. 2. ME3F (See Below for ME3H): Remove three cap screws (Ref. No. 14B, …