Regulus LYRA 1000 VVS Installation And Operation Manual

3, Regulus LYRA 1000 VVS 3 │ 1 - Description Regulus LYRA Thermal Stores are intended for accumulation and subsequent distribution of thermal energy from solid-fuel fired boilers, heat pumps, solar collectors, electric boilers etc. The Thermal Store shall be always connected to a sealed heating circuit. The tank com…

7, 7 │ MOUNTING INSTRUCTIONS WARNING! At least 20 °C and 4 persons are necessary to mount the insulation. All threaded connections shall be sealed either with a thread sealant or with the gaskets included in separate kits. 1. Remove the tank from its pallet and place it to its approximate po…

10, │ 10 11. Fit the fresh water station (code either 9717 or 9913) using 4 screws M6x16 with washers (codes 12996 and 7853) - all these components are included in the Kit code 12226. 12. Connect the TSV3B assembly (code 12687) using a 3/4“ pipe, 100 mm long (code …

9, 9 │ 8. Fit the 3/4” ball valve (code 998) to the tank and the 3/4” FF hex nipple (code 6970) into the valve, both these components are included in the Kit code 13234. Turn the ball valve into the position shown in the fig. 9. Fit the ball valve and elbow assembly (code 13236) …

4, │ 4 3 - Technical Data and Dimensions 4 - Operation This Thermal Store is designed to heat water and accumulate heat for space heating in domestic or industrial applications, however always in sealed pressure circuits with forced circulation. In the heat store, heating water is heate…

13, 13 │ 20.Connect the T-piece assy at 3 points, see fig. 21. Using the 5/4” pipe 580 mm long, connect the T-piece assy with the ball valve assy. 22. Fit two thermometers (code 10474), included in Kit 13237, and 6/4” and 1/2” plugs or electric heating elements and a safety thermost…