Regal Browning TorqTaper Plus Series Installation And Maintenance Manual

3, 1. Shaft Mount Reducer Installation Instructions For long service and dependable performance, a shaft mount reducer must be rigidly supported and accurately aligned. The following instructions are a step-by-step guide to meeting these requirements for a Browning ® TorqTaper Plus shaft mounted…

9, 3. Hydraulic and C-face Motor Mount Installation Instructions 3.1.1 Before installing the hydraulic motor, measure dimensions A , B, and spline length (SL) on the hydraulic motor. (See Figure 3-1). Three conditions must be met: Condition 1: Dimension A on the motor must be less than the…

6, Figure 2-1B Oil Levels A and B, Drain and Breather Locations (800 only) Figure 2-2 A Vertical Mount Oil levels, Drain and Breather Locations (107 through 608) 2.1 Oil Level 2.1.1 Shaft mount reducers require different amounts of oil in the various mounting positions. For the conven…

5, Regal Browning TorqTaper Plus Series 1.5.3 On the side opposite of the input shaft, thread the bushing ring onto the hollow quill until the bushing ring is ush with the end of the hollow quill. Rotate the reducer input shaft to align the keyway in the hollow quill with the bushing/shaft key. Position the reducer…

4, Type 2 Bushing • Position the reducer on the driven shaft with the bushing ring facing out toward the end of the shaft. • Move the reducer into position by rotating the input shaft as required to align the driven shaft key with the keyway in the reducer quill. • Locate the reducer on the…

10, Browning and TorqTaper are trademarks of Regal Beloit Corporation or one of its afliated companies. ©2015 Regal Beloit Corporation, All Rights Reserved. MCIM15015E • Form 9191E • Printed in USA TERMS DEFINITION Backstop A device that is used to prevent reverse rotation up to …