MultiTrode MultiSmart Installation & Operation Manual

110, MultiSmart Installation & Operation Manual Press Config to change additional settings for the level device. For Analog devices for example, the port it’s connected to and the range (zero and span values) can be entered. For Probes and DuoProbes, the model number, units and depth o…

233, MultiSmart Installation & Operation Manual 33 Web Server MultiSmart has web server functionality, which is valuable for monitoring MultiSmart details on remote machines, or for where there is no local LCD. Most of the information which can be viewed by info screens on the MultiS…

192, MultiSmart Installation & Operation Manual 22.2.5.1 Modbus / DNP Slave Scroll down to the DNP or Modbus slave and press Select. Enabled – Select this for the slave to be active. Comms Channel – Select from Serial 1, Serial 2, RS485 A, RS485 B, TCP/IP 1, TCP/IP 2, TCP/IP 3, M…

258, MultiSmart Installation & Operation Manual Index 1 10 Sensor Probe .............................................................. 43 A ACROMAG Ethernet Units ............................................. 102 ADAM Ethernet Units ...........................................…

88, MultiSmart Installation & Operation Manual 12 Fill / Empty & Pump Setpoints, Alarm Setpoints, Delays 12.1 Fill / Empty (Charge / Discharge) This parameter is selected during the Setup Wizard, as described in Section 9. 12.2 Default Pump and Alarm Setpoints The MultiSmart pum…

13, MultiTrode MultiSmart MultiSmart Installation & Operation Manual 4.2 Intuitive Operator Interface The MultiSmart has screens which have been designed for operators of pump stations. The operator can see at a glance: • Level • Pump mode • Pump availability • Detailed fault information •…