TAWI VM30 Operation & User’s Manual

5, 5 g PTC M 3 u I > I > I > U1 V1 W1 M 3 M 3 RECOMMENDATION OFF (O) ON (I) ≥60s 21 MAX 10/h L3L2L1 W1V1U1 L3L2L1 d e f h 4. TAWI strongly recommends that the PTC is con- nected to a thermal relay for overheating protec- tion (e). Wait at least 60 seconds and let the fan stop befo…

21, 21 5 Troubleshoot This chapter provides information on how to investigate or rectify problems that may occur. Actions marked with (*) must be carried out by TAWI or a TAWI authorised service technician. Problem Likely caused by Action required Vacuum lifter does not lift Vacuum pump not started C…

16, 16 Use lifter Review and perform relevant inspections. See 6 Service & maintenance on page 19. The lter has a control valve to reduce the lifting speed when handling light loads, see Install filter unit and air tubes on page 7. 1. Move the lift tube so that it can be placed dir…

9, TAWI VM30 9 e dcba 2cm Model VM30-50 VM60-80 VM100-270 No. of clamps Two clamps (top swivel) One clamp (suction head) One power clamp Two power clamps Torque >6 Nm >18 Nm > 20 Nm Mount suction head 1. On the suction head side: repeat steps 1-5 from Mount top swivel on page 8. Put the ru…

2, 02 1 Overview TAWI VacuEasylift is a line of lifters that lifts and lower loads using vacuum. TAWI VacuEasylift provide lifting and transportation aid for loads up to 270 kg and can be equipped with dierent tools and accessories. The lifters are currently available in nin…

20, 20 Inspections The following inspections are to be carried out. Quarterly inspections by inhouse maintenance 1. Double check (carry out) all inspections mentioned in Weekly inspections by operator. 2. Check the lift and crane system or jib rig for signs of damage/wear and that bolts and pin…